MIO–CCE–4K/3G
SMPTE ST 2110/4K/3G/HD/SD Closed Caption Encoder with Media–to–IP Streaming
Revision 1.0
Page - 11
4.3.3. SNMP Trap Servers
This section contains controls for connecting for setting trap server for alarms, with the possibility to connect
up to three trap servers.
Trap Destination Enable:
This control will enable or disable the designated trap server.
Trap Server IP Address:
This field allows the user to enter the IP address for the designated trap server.
Trap Ethernet Port:
This control enables the user to select which network port is used to send alarm
messages to the designated trap server.
4.4. TIMING
Figure 4-5: WebEASY
®
- Timing
4.4.1. External Genlock Faults
External Genlock Fault Present:
This display will turn red if a genlock fault is detected, remains green if
no genlock fault is found.
External Genlock Fault Send Trap:
This slider control allows the user to enable sending a fault notice to
the trap servers enabled in Section 4.3.3. Slide the control to the right to enable trap, slide to left to disable.
4.4.2. Genlock Input Status
Genlock Health:
This section displays the current genlock health, this is based on load increasing and jam
count not increasing.
Genlock Input Standard:
This field displays the genlock input standard for the genlock input signal.
