HD9690 Series HDTV Graticule Generator Manual
Page 4-14
Revision 1.5
DESKTOP CONTROL PANEL OPERATION
4.4.3.2.
Controlling the Grid Size and Position
(Objects not centred, Aspect Ratio Off)
Setup menu
Force centre
no
Auto Aspect ratio
off
When
Force Centre
is Off and, and
auto aspect ratio
mode is Off the left shaft encoder is used to adjust
the top of the
grid
and the right shaft encoder is used to adjust the bottom of the
grid
when the
POS
button
is selected. The left shaft encoder is used to adjust the left side of the
grid
and the right shaft encoder is
used to adjust the right side of the
grid
when the
SIZE
button is selected.
4.5.
CONTROLLING THE MASK OBJECT
The
mask
object consists of a horizontal masked area at the top and bottom of the raster, and a vertical
masked area at the left and right side of the raster. Throughout the remainder of section 4.5.2.2 the
mask
dimensions refer to the boundaries between the masked and unmasked area as shown in Figure 4-4. The
left side of the mask is the first unmasked pixel; the right side is the last unmasked pixel. The top of the
mask is the first unmasked line and the bottom of the mask is the last unmasked line. The horizontal
transitions from mask to image are shaped as shown in Figure 4-4. The vertical transitions from mask to
image are hard transitions.
Mask Width
Mask Left is first
unmasked pixel
Mask Right is last
unmasked pixel
Unmasked image
Figure 4-4: Mask Position and Size