evertz 8010TM, Instruction Manual

Page: 90 / 98

Model 8010TM SDI Time Code Master Manual
Page 5-2
Revision 1.5.1
TECHNICAL DESCRIPTION
5.1.5. Physical
Single Power Supply Version:
Dimensions : 19” W x 1.75” H x 7.75” D
(483mm W x 45mm H x 196mm D)
Weight: 7 lbs. (3.2 Kg)
Dual Power Supply Version:
Dimensions : 19” W x 1.75” H x 18.75” D
(483mm W x 45mm H x 477mm D)
Weight: 8 lbs. (3.5 Kg)
5.2. JUMPERS AND SWITCHES
5.2.1. DIP Switch Functions
The main circuit board contains an 8 position DIP switch (S1) that invokes setup and diagnostic
functions. Most users will have no need to alter the factory switch settings. The functions of each switch
are described below.
Switch Name Normal Function when Open Function when Closed
1
Bypass Mode Open Non-bypass Bypass
2
Broadcast Mode Open Normal Operation
Unit powers up in "Broadcast Mode" ;
generator time code data is sent out
the serial DB-9 port.
3 Not used Open
4
Factory Reset Open Reset to factory defaults on power up
5
Not used Open
6 Quick Boot Closed Display boot messages Faster boot up
7
Not used Open
8 Engineering Mode Open
Special Engineering functions such
as calibration of the Colour frame
circuitry
Table 5-1: DIP Switch Functions
5.2.2. Configuring the Serial Port
The Serial port can be configured for various pinouts, as described in Chapter 2. During manufacture,
the serial port is configured for RS-232 DCE.
To reconfigure the serial port it is necessary to unplug the SDI Time Code Master and remove the top
cover. Figure 5-1 shows the settings of jumper block J9 on the main circuit board for the various
configurations available. The pinouts corresponding to RS-232 DCE and RS-422 tributary
configurations are given in Chapter 2. It is impossible to tell whether the serial port pinout has been
altered without opening the unit for inspection.