2430RX2-10G Series
10G Video to HDMI/SDI Converter
Page - 4
Revision 0.1
2.3.
HARDWARE INSTALLATION
NOTE: SFP’s must be ordered separately
To successfully install the 2430RX2-10G you will require the following:
1. Unused IP address on the network.
2. 9Pin RS-232 serial cable
Before handling this device it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap be worn.
Ensure that the device is powered up and the green LED is on. Connect the device via the COM port
using a 9-pin Serial Cable. Connect the Female end of the serial cable to the serial port of your PC.
Connect the the opposing Male end to the 9-Pin connector on rear of unit. In order to begin
configurations ensure the below settings are configured properly:
Baud: 115200
Data: 8-BIT
Parity: none
Stop Bits: 2
Flow Control: none
Open TeraTerm (if using Windows XP or older open Hyper Terminal) to make the required changes to
the IP address on the card. Use the login
customer
and password
customer.
2.4.
CONFIGURING BASIC NETWORK SETTINGS
To make changes to the IP address select
Network Setup
. Set the IP address to the desired subnet
as well as set the
Gateway
. Make the same changes for the IP address and Gateway of Port 2 as
required. When done
Exit (X)
the Network Setup and
Save and Exit (X)
from the Main Menu to ensure
all changes are saved.
Power Cycle the 2430RX2-10G to ensure all changes are loaded to the card.
2.4.1. Inband Control Configuration
This sub-menu enables the user to configure the settings for unicast traffic forwarding for each of the
two data ports.. The following steps should be followed to ensure proper confirguration:
1) Connect COM port to 2430RX2-10G
2) Login when prompted: username
customer
password
customer
3) Select Option (6) and/or (10) to enable inband control for data ports 1, 2 or both.
3) Select (1) for Enable
4) Select (Y) to confirm
5) Select (X) to save and exit from the 2430RX2-10G main menu
After the Inband control configurations have been enabled, wait for the unit to reboot.
