CCTV testerPRO User’s Manual
3.9 PTZ address scanning
Search up the ID of PTZ camera.
Note:
Please isolate the PTZ camera with other PTZ cameras before searching up. Otherwise all the
PTZ cameras in the same system will pan at the same time.
Press
keys to “Device setting” menu:
Press
key to confirm after change “Address search:”
to “on”, which add address scan sub-menu. Press
to switch the sub-menu as illustrated:
(
Note:
The system returns to “OFF” after shutdown, and the
scan sub-menu closes automatically. Set “ON” again for next
use.)
Press
key to set: protocol, communication port,
communication rate, make them same as the PTZ camera
Press
or
key, the address values is constantly on the rise or decrease.
NEAR: The tester will search up the ID quickly and continuously(from 1 to 256). When the ID
is searched, the PTZ camera will pan right. At this time, please press any key to stop
searching up.
FAR: The tester will search up the ID quickly and continuously(from 256 to 1). When the
ID is searched, the PTZ camera will pan left. At this time, please press any key to
stop searching up.
WIDE: The tester will search up the ID step by step (from 1 to 256). When the ID is searched,
the PTZ camera will stop panning.
FAR: The tester will search up the ID step by step (from 256 to 1). When the ID is searched,
the PTZ camera will stop panning.
Ver: STPV1.32
Page.18
.
