exclusion mode.
2. Press the button three times within
1.5 seconds to put the unit into
exclusion mode.
Reset
(This
procedure
should only
be used
when the
network
primary
controller
is
inoperable.
)
1. Press the button three times within
1.5 seconds to put the unit into
exclusion mode.
2. Within 1 second of step 1, press
link key again and hold until LED
is off (about 5 seconds).
3. Node ID is excluded. The
device reverts to factory default
state and will be in auto-inclusion
mode for 4 minutes.
Failed or successful results in including/excluding the ID can
be viewed on the Z-Wave
TM
Controller.
Note
: If you are connecting this unit to a Z-Wave
TM
Controller that utilizes
the S2 security protocol, you may be asked to enter a 5 digit Device
Specific Key (DSK) that is unique to each unit by your controller. This can
be found in one of two places:
- on the QR code label on the unit
- on the insert card inside the packaging
Symptom
Cause of Failure
Recommendation
Device not
responding and
LED not
displaying
The device is not
connected to the
mains power
correctly
Check if
connection is
correct, or voltage
is too high or too
low
Device
malfunction
Send the device to
be repaired
LED displaying,
but cannot
control On/Off
status of
connected load
The connected
load has its own
on/off switch
Turn the switch of
the connected
load to On.
Can press
RF interference is
Wait for a while
button to control,
but cannot
control by RF
occurring.
Someone nearby
might be emitting
RF signal of the
same frequency
and retry the
operation
Specification
Operating Voltage 230VAC/50Hz
Maximum Load
UK Plug
Resistive load: 2990W
Incandescent load: 1500W
Fluorescent load: 15 x 40W
LED: 200W
Range
100 m line of sight
Frequency Range AN370-3:868.42 MHz(UK)
** Specifications are subject to change and improvement without
notice.
Warning:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health
and well-being.
When replacing old appliances with new once, the retailer is legally obligated to
take back your old appliance for disposal at least for free of charge.
www.everspring.com
50 Sect. 1 Zhonghua Rd Tucheng New
Taipei City 236 Taiwan.