5
1-10 USB Interface
The built-in USB interface is compatible with Everspring PC software. Scene and Schedule editing, RF device code
learning, TV & DVD button learning, and time setting can be done via PC software.
Note:
Please switch the unit to RF mode before entering USB interface. Avoid the unit entering time setup, learning
mode or scene/schedule setup while connecting USB interface to PC.
OPERATING INSTRUCTIONS
To control on/up and off/down status of each target device, follow the below steps for operation:
1. It is of great importance to proceed with
2-2 learning mode
as prerequisite.
2. To display device status (e.g.
implies fully arm), press single/tens digit button (
,
and
).
3. Press single/tens digit button and
for on/up; while pressing single/tens digit button and
for off/down (please
refer to table 1 on page 11 for more operating instructions).
4. Using
(All)
and
will turn on all of the devices; whereas
(All)
and
will turn off all of the devices at a
time.
Note:
When using
(All)
feature, it is only suitable for use with
and
type of products, while
and
type of products cannot be applied.
PROGRAMMING INSTRUCTIONS
2-1 Time Setup
Set the present time as desired.
1. Press and hold the button next to
for 3
seconds.
2. Either AM or PM is flashing. Use
to choose
AM or PM (e.g. ).
3. After pressing
, HH of HH:MM starts flashing
(e.g. ). Use
or
~
to set
HH. Further pressing
offers MM adjustment.
Use
or
~
to adjust MM. (
Note
: Use
to choose the item that needs to be
adjusted)
4. Further pressing
will enter day of week
selection. Use
to choose day of week
(e.g. ). Press
continuously will return to step 2 for edition.
5. Upon completion, press
to save and exit.
2-2 Learning Mode (RF)
To be compatible with U-net devices:
1. Press
for 3 seconds until
is flashing then
release.
is on
steadily, which implies that the
unit enters learning mode. Learning timeout period
is 30 seconds.
2. The unit will distribute an undistributed device
number (
~
) automatically, which will flash as
an indication. While if a device number has been
allocated, it will be on steadily. Alternatively, press
or single/tens digit button to choose a device
(
~
) as desired, then press
as
confirmation.
3. The unit will emit its ID code to target device and
resume 30 seconds countdown.
(
Note:
To terminate 30 seconds countdown before
timeout and return to step 2, please press
).
4. Once the unit receives ID code of target device, the