SELECTING A LOCATION
1. Give consideration to the weight of the unit when operating (filled with water). Operating weights of the Insurice PF
Systems are:
• Insurice PF Single - 7SI - 16 lbs (7.26 kg)
• Insurice PF Twin - 7SI - 29 lbs (13.15 kg)
• Insurice PF Triple - 7SI - 37 lbs (16.79 kg)
• Insurice PF Quad - 7SI - 43 lbs (19.50 kg)
2. The location should allow for:
• Minimum clearance of 2
1
⁄
2
" under the cartridge(s) so it can be lowered for removal and replacement.
• Adequate space for “in” and “out” water line connections.
• Be near a drain for flushing and near a 110V outlet if the accessory (sold separately) Everguard™ Low Pressure Alarm is
used. See Step 5.
OPERATING SPECIFICATIONS
• For cold water use only.
• Operating Temperature: 35 – 100°F (2 – 38°C)
• Min.-Max. Working Pressure: 10-125 psi (0.7-8.6 bar), non-shock
• Flow Rate:
System
Replacement Cartridge
Flow Rate
Capacity
Insurice PF Single –
7SI
7SI
3.5 gpm (13.25 Lpm)
25,000 gal. (94,635 L)*
Insurice PF Twin –
7SI
7SI
7.0 gpm (26.50 Lpm)
50,000 gal. (189,271 L)*
Insurice PF Triple –
7SI
7SI
10.5 gpm (39.75 Lpm) 75,000 gal. (283,906 L)*
Insurice Quad PF - 7SI
7SI
14.0 gpm (53.00 Lpm) 100,000 gal. (378,541 L)*
INSTALLATION INSTRUCTIONS
1. Use the predrilled mounting holes in the manifold bracket as guides. Mark and drill anchor holes. Mount securely. See
Figures 1 – 4 .
2. Shut off power to equipment.
3. Connect outlet port of the Insurice PF System to equipment served. Always use an NSF approved pipe dope or Teflon
®
tape at all connections. Use a backup wrench on all fittings while connecting to avoid excessive stress on the system
components.
4. Install a manual shut-off valve leading to the system for servicing.
5. Connect minimum 3/8" water line to the Insurice PF Single System inlet. Use a minimum 1/2" for Insurice PF Twin, Triple
and Quad Systems.
6. Connect tubing to flushing valve and run to drain. The cross fitting has a flushing valve installed
on the bottom.
Note:
Some municipal plumbing codes and good sanitary practices require an air gap at the
drain termination point.
Insurice PF Single 7SI System
Insurice PF Twin – 7SI System
Insurice PF Triple – 7SI System
Insurice PF Quad – 7SI System
*As tested by Everpure
Air Gap
FILTRATION & PROCESSING SOLUTIONS
7SI INSURICE PF SYSTEMS INSTRUCTION & OPERATION GUIDE
EVERPURE
®
EVERPURE
®
7SI INSURICE
®
PF SYSTEMS
