21
Component Identification and Explanation
1
2
3
5
6
Number
Component Identification
Component Note
1
Protective Cover
Keep down and in place during welding activities and in storage.
2
Door and Latch
Keep door closed while in use. Only open for wire replacement and starting
3
Negative Terminal (
-
)
(DINSE 25 Type,
3/8”
approximate dia.)
For MIG (GMAW): This is the location of the work clamp
For Gasless (self
-
shielded) Flux
-
Cored (FCAW): This is the location of the wire feeder
lead.
4
Wire Feeder Lead
(DINSE 25 Type,
3/8”
approximate dia.)
This cable and DINSE connector is used to select the polarity of the wire feeder. This
connects internally to the wire feeder to supply power to the torch. The unit will not weld
without connecting this to either the Positive (+) Terminal or Negative (
-
) Terminal and
connecting the work clamp to the remaining opposing Terminal.
5
2 Pin Control Connector
This connector is the control connector for the Spool Gun. It supplies operating voltage
to the drive motor on the gun.
6
Positive Terminal (+)
(DINSE 25 Type,
3/8”
approximate dia.)
For MIG (GMAW): This is the location of the wire feeder lead.
For Gasless (self
-
shielded) Flux
-
Cored (FCAW): This is the location of the work clamp.
7
Handle
Front Panel View
4
7
Summary of Contents for Cyclone 200E
Page 33: ...33 ...
