Customer Service 1-888-707-1880
Dyaco Canada Inc. 2014
Email: [email protected]
29
Troubleshooting
I. Engineering Mode
Remove the safety key and reinsert it after pressing the ENTER and STOP buttons together to
enter the engineer mode. Press the ENTER button once to select roller diameter (60), km or
miles, speed (0.5mph to 10mph) and incline (12). Press FAST button and SLOW button to
change the value. Press the START button to finish. The treadmill begins to calibrate itself and
will leave the engineering mode when the operation is completed.
II. What to do when error occurs
1.
E0:
Safety key is not inserted
2.
E1:
Missing speed signal
To clear:
Check and make sure that speed signal connector is properly connected.
3.
E2:
Overloaded
To clear:
Press the power switch to the OFF position and then back ON to clear the error
message.
4.
Er:
Incline motor error
(in the incline window)
To clear:
Press the power switch to the OFF position and then back ON to clear the error
message.
5.
E4:
Motor error
To clear:
Check and make sure that motor cable is well connected and the power is stable.
Resume power to clear error message.
6.
E6:
Insufficient of power
To clear:
Check if voltage is too low or
if the controller
has been damaged. Replace
the
controller
if necessary.