Everglades 210 CC 2012, Owner'S Manual

Page: 35 / 126

35
Operation
CAUTION
Notice:
Your dealer will give instructions on how to
load, fasten and launch your boat.
BOATS HAVE BEEN DAMAGED BY TRAILERS THAT DO NOT
PROPERLY SUPPORT THE HULL. ALWAYS MAKE SURE THE
TRAILER BUNKS AND ROLLERS ARE ADJUSTED SO THEY
ARE NOT PUTTING EXCESSIVE PRESSURE ON THE LIFTING
STRAKES AND ARE PROVIDING ENOUGH SUPPORT FOR THE
HULL. HULL DAMAGE RESULTING FROM IMPROPER TRAILER
SUPPORT IS NOT COVERED BY THE EVERGLADES WARRANTY.
Before Going Out On The Highway:
• Side curtains, clear connector, backdrop
and aft curtain must be removed when
trailering. Canvas enclosures are not designed
to withstand the extreme wind pressure
encountered while trailering and will be
damaged. Always remove and properly store
the enclosure before trailering your boat.
• Lower the console windshield and secure it in
the down position. Extreme wind pressure
encountered at highway speeds may cause
damage to the windshield if it is in the up
position.
• Make sure the tow BALL and TRAILER COUPLER
are the same size and bolts and nuts are tightly
secured.
• The COUPLER MUST BE COMPLETELY OVER
THE BALL and the LATCHING MECHANISM
LOCKED DOWN.
• Make sure the TRAILER IS LOADED EVENLY
from front to rear as well as side to side and
has the correct weight on the hitch. Too much
weight on the hitch will cause the rear of the
tow vehicle to drag and may make steering
more difficult. Too little weight on the hitch
will cause the rig to fishtail and will make
controlling the tow vehicle difficult. Contact
the trailer manufacturer or your dealer for the
correct weight on the hitch for your trailer.
• The SAFETY CHAINS must be attached
crisscrossing under the coupler to the frame
of the tow vehicle. If the ball was to break,
the trailer would follow in a straight line and
prevent the coupler from dragging on the road.
Make sure the trailer emergency brake cable
or chain is also installed to the tow vehicle
frame.
Backing Procedure for Boat Trailers
• Make sure the LIGHTS on the trailer function
properly.
• CHECK THE BRAKES. On a level parking area
roll forward and apply the brakes several times
at increasing speeds to determine if the brakes
on the tow vehicle and trailer are working
properly.
• Make sure the tow vehicle has SIDE VIEW
MIRRORS that are large enough to provide an
unobstructed rear view on both sides of the
vehicle.
• CHECK THE TIRES and WHEEL BEARINGS.
Notice:
Make sure your towing vehicle and trailer are
in compliance with all state and local laws.
Contact your state motor vehicle bureau for
laws governing the towing of trailers.