5
3.1
Terminal Block
Alarm Input: 16
Alarm Output: 1
RS-485: 1
Alarm
IN
16
15
14
OUT
COM
NO
RS485
-
+
G
10
9
8
7
6
5
4
3
2
1
13
12
11
G
G
G
G
G
4.
Turning On / Off the Power
Before powering on the NVR, please make sure the internal HDD have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the NVR.
Simply plug in the power source and then press the Power Switch on. The POWER LED will light
up if power is normal and the NVR will enter the System Initialization process.
When the process is done, it’s required to set up a password for the administrator account
immediately in order to protect your privacy.
To turn off the power, click the Shutdown button on the Exit page (OSD menu > Exit >
Shutdown) and then press the Power Switch on the rear panel of the NVR.
Note: If you forget the password when login, you can try the following instructions:
•
If you have pre-configured the email settings, you can just click “Forget Password” on the
login window and the system will send the password or a super password to the setup
email address.
•
If you have never configured the email settings, please mail the MAC Address, Serial
Number and the Model Name to [email protected] to get a temporary password.
