5
Orange with white stripe
Orange
Green with white stripe
Blue
Blue with white stripe
Green
Brown with white stripe
Brown
7.
Connect the camera to power. You can either connect the camera to a
12VDC power source or to a PoE switch using the PoE cable.
8.
Access the camera live view. See 4. Accessing the Camera.
9.
Adjust camera angles and then tightly twist back the Outer Housing.
3.2
EZN Series
1.
Drill three holes on the surface according to the Camera Base and then
push the supplied 3
Screw Anchors
into the holes. Drill another hole in
the middle within the 3 screw holes if you wish to run the wires into the
surface.
2.
Before screwing the Camera Base to the surface, thread the cables
either from the side-cut of the Camera Base or through the surface.
3.
Screw the camera to the surface using the supplied 3
Screws
.
Screw Anchor
Screw
Surface
4.
Connect the camera to the network using the supplied
Cable Gland Kit
.
a.
Insert a RJ-45 network cable (without the RJ-45 connector on the one
end) through the supplied
Waterproof Ring
,
Cable Gland
,
Stopper
and
Screw Cap
accordingly.
