Everex CloudBook CE1200V Series, User Manual, Page: 34 / 87

CloudBook
User Guide
34
2.3 Starting Your CloudBook
The Power/Resume button is found on the center of the base unit. Press the
Power/Resume button to start your CloudBook and check that if the Power
LED turns on.
After a few seconds, the CloudBook’s display will turn on and your
CloudBook will begin to execute the Power On Self Test or POST to check if
all system components are running properly. Any error found during the test
will be displayed on the screen and may generate short beep sound as well.
After the test, the screen will also display a message " press <F2> to enter
SETUP ". You don’t need to run this program at the moment as your dealer
already made the necessary settings for your CloudBook optimal operation.
Refer to Chapter 6 on running the SETUP program later.
After the test has completed, your CloudBook will start to search and boot up
the operating system from your hard drive. The CloudBook normally comes
with a Linux operating system pre-installed in your hard drive. Consult the
Linux manual on how to use the program. If not, contact your dealer for
assistance.