REFRIGERATION
23
Keg Installation Instructions
Keg Installation Instructions
NOTE: The CO
2
distributor can be used to share the single CO
2
tank with multiple kegs.
*
a. Connect the open end of the CO
2
line to the keg coupler's hose barb connection,
pushing the hose onto the barb connector as high as you can without damaging the hose.
Secure the hose to the connector using a clamp. Place the clamp as high up as possible
without it interfering with the operation of the valve.
a. Install the rubber washer onto the beer line hex nut fitting.
b. Remove the plastic protective cover from the keg coupler, if equipped.
c. Connect the beer line from the tower to the keg coupler.
It connects to the screw type connection on top of the coupler.
a. Pull the tap handle out and away from the keg coupler and push down until it locks into position.
A click noise should be heard once the handle is in its final lock position.
1. CO
2
tank placement (inside or outside of the refrigerated cabinet)
a. Outside of Cabinet - Drill a hole on the back wall of the unit, only in the areas indicated in figure;
Drilling in any other place may cause damage to the unit's wiring.
b. Inside of Cabinet – Depending on the unit model and size of the equipped keg, you may be able to fit
the CO
2
tank inside of the refrigerated cabinet; This setup requires no drilling.
a. Ensure that the CO
2
regulator's shut off valve is closed.
The switch's lever should be perpendicular to the CO
2
line when it is in the closed position.
b. Connect one end of the CO
2
line to the CO
2
regulator's hose barb connection,
pushing the hose onto the barb connector as high as you can without damaging the hose.
Secure the hose to the connector using a clamp. Place the clamp as high up as possible
without it interfering with the operation of the valve.
c. If the CO
2
tank has been placed out of the refrigerated cabinet,
feed the hose through the hole that was previously drilled in the back of the unit.
2. Connect CO
2
Line to CO
2
Regulator
a. Ensure that the CO
2
tank is full and closed.
b. Attach the CO
2
regulator to the CO
2
tank using the large nut that is part of the regulator.
3. Connect CO
2
Regulator to CO
2
tank
a. IMPORTANT: Ensure that the keg pull handle is closed (upper position).
b. Install the keg coupler onto the keg's locking neck and turn clockwise to lock into place.
4. Connect Keg Coupler
5. Connect CO
2
Line to Keg Coupler
6. Connect Beer Line to Keg Coupler
7. Tap Keg
