9
THE EVOLUTION OF PORTABLE OUTDOOR COOKING
BARBECUE ASSEMBLY
The barbecue and hood comes pre-assembled in a single package, but a number of components need fitting
to their correct position. Only a medium size Philips screwdriver is needed. For pictures of parts see the parts
lists near the end of this booklet.
UNPACKING THE UNIT
Take the foam covered unit out of the carton, and place on a clean, flat surface. Carefully remove the foam
from each end and take off the protective plastic bag (take care not to kink or damage the hose). Take the
hood handle and fixings out. Open the hood and remove the plastic servery bins, the fat tray, foil tray & the
foam packing. Remove the plate and remove any packaging inside the chassis. Remove all plastic bags from
parts and replace the hot plate.
FITTING THE FOLDING SERVERY BINS
The folding servery bins can be fitted or removed,
depending on the circumstance. To fit, the bin is
held with the upper face to the barbecue at 90° to
the servery, with the hinges over the clips in the
serverys, and pushed down (to remove, use the
same position & pull the hinges out of the clips).
The bins can be folded on top of the serverys to
lift or store the unit, or folded out when in use.
The bins are opened by pulling on the clips at the
outer edges. These are meant for storage of up
to 3kg each & not for supporting, moving or
lifting the barbecue, or as work surfaces. Pushing
down too hard on them could break either the hinge or clips.
FITTING THE HOOD HANDLE
Open the hood of the barbecue. Place a fibre washer on the top of each hole
and fit the handle over the holes. Using a Philips screwdriver and the
supplied screws, screw through the hood and washer into the handle on both
sides. Hand tighten both screws so the handle does not wobble.
FAT TRAY & FOIL TRAY
Place a foil tray into the fat tray and slide the fat tray under the barbecue in
the frame at the bottom of the chassis. The fat tray frame
is clipped into the brackets at the bottom of the chassis.
PACKAGING
Remove all internal cartons and packaging from within the
barbecue/hood assembly. Remove all external packaging
and remove the appliance from the packaging base
before operation. Recycle as per your local government laws.
9
