www.event-lighting.com.au
2
Safety Instructions
Warning
•
Do not open this device, there are no user serviceable parts inside. Risk of electric
shock.
•
Do not look at the light source when the device is on.
•
CAUTION:
This unit’s housing may become hot during and after operation.
•
Install this device in a location with adequate ventilation, at least 20 inches (50 cm) from
adjacent surfaces.
•
Do not leave any flammable material within 20 inches (50 cm) of this unit while operating
or connected to power.
•
Use a safety chain when mounting the device overhead.
•
Do not operate this device outdoors or in any location where dust, excessive heat, water
or humidity may affect it.
•
Do not operate this device if the housing, lenses, or cables appear damaged.
•
Do not connect this device to a dimmer or rheostat.
•
Only connect this device to a grounded and protected circuit.
•
Only use the hanging bracket to carry this device.
•
In case of a serious problem, stop using this device immediately.
•
Do not operate this device at ambient temperatures higher than 40° C (104° F).
Power Input and Power Linking
This device has an auto-switching power supply that works with 100-240 V AC, 50/60 Hz input.
Link up to the maximum of 8A. DO NOT exceed this.
Fuse Replacement
If the fine wire fuse of the device fuses, replace it with one of the same type and rating. Before
replacing the fuse, disconnect from mains power.
Procedure:
1.
Unscrew the fuse holder on the rear panel from the housing with a fitting screwdriver.
2.
Remove the old fuse from the fuse holder.
3.
Install the new fuse in the fuse holder
4.
Replace the fuse holder in the housing and secure it.
Product Installation
This device can be mounted in many orientations provided each individual device is secured by
the use of the correct mounting bracket. Use a safety chain when mounting this device overhead.
