28
29
Rear-facing
Rear-facing Installation with
Lower Anchor Connectors
DO NOT
use this child restraint if it moves more than
2.5 cm (1 in.) side-to-side or front to back at the
rear-facing belt path. Serious injury or death may result
from poor installation. If you can not tightly secure the
child restraint, try again or move it to another location,
or install with the vehicle seat belt.
Using your full weight, push the child restraint firmly
into the vehicle seat while pulling up on the lower
anchor connector assembly strap to tighten.
The lower anchor connector assembly strap must be
as tight as possible.
If you can move the child restraint more than 2.5 cm
(1 in.) side to side or front to back at the rear-facing
belt path, the lower anchor connector assembly strap
is not tight enough. You will need to try again, find
another location for your child restraint, or install with
). To remove the lower
anchor connector assembly strap, go to page
6
WARNING
Rear-facing Installation with
Lower Anchor Connectors
SecureRight™
Quick Connector™
Clip
Strap
Adjuster
Refer to your vehicle owner’s manual to locate the lower
anchor bars on your vehicle seat. Attach the right
hook, or clip, to the right anchor bar and the left hook,
or clip, to the left anchor bar.
DOUBLE CHECK
that the
lower anchor connector hook is fully engaged by pulling
hard on the lower anchor connector strap.
5
Know Your Lower Anchor
Connector Assembly
The lower anchor connector assembly that comes with
your child restraint will be one of the two types below.
Hook
Adjuster
Strap
