30
31
Rear-facing
Rear-facing Installation with
Seat Belt
Rear-facing Installation with
Seat Belt (cont.)
Make sure the harness
straps are in one of the
four lower
harness slots.
The harness straps
MUST
start at shoulder height
or lower, using the strap
slots closest to your child’s
shoulders, as shown.
Attach the harness
straps to the splitter
plate using the
infant position
) on the harness
straps.
As your child grows, you
can attach the harness
straps to the splitter
plate using the pockets
at the end of the straps.
2
ARROW
MUST
BE LEVEL WITH
GROUND WHEN USED REAR-FACING
REAR OF VEHICLE
Infants
MUST
always ride facing the rear of
the vehicle.
Adjust the child restraint to the
recline
position
). Place the child restraint in your
vehicle
rear-facing
. Adjust the restraint so that the level
arrow is level with the ground.
NEVER
turn a child restraint
forward-facing
with a child who
weighs less than 10 kg (22 lbs).
Crash forces may cause serious
injury or death.
For complete child requirements for
forward-facing use, see page
.
ARROW
MUST
BE LEVEL WITH
GROUND WHEN USED REAR-FACING
REAR OF VEHICLE
IMPORTANT:
Make sure both harness straps are
installed completely on the splitter plate, as shown.
1
WARNING
DO NOT
use the two upper set of harness slots
rear-facing
. The harness may not properly restrain the
child during a crash.
3
WARNING
4
Lap Belt Only
Lap & Shoulder
Belt Combination
Pull the seat pad off of the front of the child restraint.
Route the vehicle seat belt through the rear-facing belt
path and continue through the opposite opening of
the child restraint.
IMPORTANT:
Make sure the seat belt
is
in front of the crotch strap
, and it lies flat without
twisting, as shown.
Fasten the vehicle seat belt, as shown,
depending on your type of seat belt. Reconnect the seat
pad to the front of the child restraint.
