OMNI.EVELO.COM
16
OMNI.EVELO.COM
17
TuRNING ON THE OMNI WHEEL
2.8
INSTALLATION
To turn on the EVELO Omni Wheel, perform the following steps:
Make sure that both the Omni Wheel and the Console are fully charged.
1.
Switch on the Omni Wheel by pressing the power button. Wait 2-3 seconds
2.
and then switch on the Console by pressing the power button on the display.
Note:
Always power on the Omni Wheel before turning on the Wireless Console. Once a
signal strength indicator appears on the screen, the Omni Wheel and the Wireless Console
are connected. Turning on the Console before the Omni Wheel will result in an error message
(E-0).
The EVELO Omni Wheel’s integrated energy-saving technology will automatically
power off the system if the bike stops for more than 15 minutes.
To re-start the system, turn off both the Omni Wheel and the Wireless Console.
Wait 3 to 5 seconds, and then turn both on again.
CONSOLE OPERATING INSTRuCTIONS
3
DATA READOuTS
3.1
Level of assistance
is selected by using
the mode button
Power On / Off
Battery life
indicator
(of Omni Wheel)
Speed
Odometer
Wireless signal strength
Battery life indicator
(of Console)
PAS (Pedal Assist) Level
Speed
The speed is displayed in kilometers per hour (Kph) or miles
per hour. The default setting is in Kph.
Odometer (DIS/ODO)
Distance is displayed in kilometers or miles. When the
maximum distance of 9999 units is reached, the number
reverts back to 0.
Battery Life Indicator for the Omni Wheel
5 bars indicate a full charge. When the level drops to 2 bars
or below, the indicator will begin to flash, letting the rider
know that the Omni Wheel needs to be recharged soon.
