Eve Audio ThunderStorm TS110, Product Manual, Page: 14 / 24

TS 110
TS 112
Power Switch
14 OPERATION
• Pure Satellite Button
Use the Pure Satellite button to mute the subwoofer (Mute function: see
Subwoofer Mute) so that the audio signal is transmitted without any
filtering to the satellite speakers. This allows you to switch easily between
sate subwoofer mode and pure satellite mode (without subwoofer
and without any filtering).
• System Volume (+)/(-) Buttons
Use the System Volume (+) and (-) buttons to increase or decrease the total
volume (sub satellites).
•
Sub Volume (+)/(-) Buttons
Use the Sub Volume (+) and (-) buttons to increase or decrease the
subwoofer volume, and thus balance the level between sub
satellites (see Subwoofer Volume Adjustment).
•
Sub Filter (+)/(-) Buttons
Use the Sub Filter (+) and (-) buttons to set the cutoff frequency of the
subwoofer’s low-pass filter and to select the LFE mode (see Sub Filter).
•
Mute Button
Press the Mute button to mute the whole system (sub satellites)
(see System Mute). Press the button again to exit the Mute mode.
3.13. Power Switch
The power switch on the rear panel disconnects the subwoofer completely
from the power grid. When powered off all settings are saved and the
power consumption is reduced to 0 watts.
After powering on again, the subwoofer will return to the state it was in
before being turned off (Standby mode, Mute mode or a given volume
level). Even if powered off via a multiple outlet power strip, the subwoofer
will return to the state it was in before being turned off.
!
In order to prevent switching noise with your monitoring system, keep in
mind the following rules:
Power all audio sources on first, then the subwoofer and then the satellites.
When turning off your system, power off the satellites first, then the
subwoofer and finally all audio sources.