Importer:
PHOYLO LTD, CZ684609501,
Enterprise House, Pass Street 2, 0L9 6HZ Oldham,
Manchester
, UK
2. PEDAL ASSISTANT
1) When you start pedal, the pedal assistant will automatically adjust motor power.
2) To install this part, you have to remove spindle. Removing requires special tools (Fig. 1a, 1c).
3) Disassemble the bike parts as shown at the Fig. 9.
4) Mout plastic wheel with magnets in correct direction of rotation (shown on wheel by arrows). Because of variety
of the assembling of the sensor (Fig. 10), the arrow on the sensor doesn‘t always match the direction of pedaling.
Correctness sensing should always be verified. Final tightening you can leave at the end of the whole installation.
Crankset
Pedal assistant
plastic wheel with magnets
Pedal
Bike
frame
Pedal
assistant sensor
Spindle
Removable
ring
9
5) There must be aprox. 2 mm space between plastic wheel and sensor. Depending on the type of bicycle, the
distance between the magnet wheel and sensor could be too small respectively large. Sensor ring sleeve can be
rotated and sensor bolted from the other side (Fig. 10).
2 mm
10
2 mm
10
6) Assembly all parts back. Before final tightening you should check the correct function of pedaling detection.
7) Before final tightening of all screws is necessary to check the correct functioning of pedaling detection.
TIP
If you mount kit on a scooter, or operate it only in accelerator mode, you can skip pedal assistant
assembly.
