Evans G16MG0240M Quick Start Manual Download Page 8

8

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT PREVIOUS NOTICE

1

1

8

2

2

9

3

3

10

11

12

13

14

15

4

4

5

5

6

7

GENERAL SAFETY

BEFORE STARTING

Before  starting  or  servicing  any    generator,  read  and 

understand  all  instructions.  Failure  to  follow  safety 

precautions or instructions can cause equipment damage 

or serious personal injury or death. Engine instructions for 

these units are contained in a separate manual. Retain 

all manuals for future reference.

Never use this generator for any aplication other than 

that  specified  by  the  manufacturer.  Never  operate 

this  generator  under  conditions  not  approved  by  the 

manufacturer. Never attempt to modify this generator to 

perform any manner not intended by the manufacturer.

For  maintenance  and  repairs,  use  only  products  and 

parts recommended by the manufacturer.

Be sure that the generator is properly grounded to an 

external  ground  path  prior  to  operation.  Refer  to  the 

section  entitled:            Grounding  instruction  for  proper 

grounding procedures.

Be sure that the generator is operated only by persons 

who have read and understand these instructions.

Be  sure  that    the  generator    is  placed  on  a  flat  level 

surface to prior and during the operation. The generator 

must not slide or shift during operation.

Do not operate the generator on wet surfaces or 

in the rain.

Keep  all  persons  away  from  the  generator  during 

operation.

Do not allow persons wearing loose clothing or jewelry to 

start or operate the generator. Loose clothing or jewelry 

may become entangled in moving components, causing 

equipment damage and or personal injury.

Keep all persons away from parts that move or become 

hot during operation.

Be sure all powered devices are shut off prior to conecting 

them to the generator.

Keep  the  generator  clean  and  well  maintained  at  all 

times.

Be sure that all tools and appliances are in good repair 

and are properly grounded. Use devices that have three 

prong power cords. If an extention cord is used, be sure 

that it has three prongs for proper grounding.

Never  use  the  generator  if  is  damaged  or  has  loose 

fittings, bolts etc. 

Use only unleaded fuel. Do not refill the fuel tank while 

the engine is running. Use precautions to prevent fuel 

spillage during refills. Be sure the fuel tank cap is securely 

in place before starting the engine. Allow engine to cool 

for at least two minutes before refueling. 

Store fuel in a safe container in a well ventilated area, 

away from open flames. 

Never operate the generator in an explosive 

or  flammable  atmosphere  or  poorly 

ventilated area.

Shut off the engine and disconnect the spark plug 

wire  before  performing  any  service  maintenance 

to the unit.

Check the fuel level before starting your generator.  For 

best  result  use  only  regular  grade  unleaded  gasoline 

(minimum 90 octanes).

Always  use  unleaded  fuel,  it  produces  less 

remainders in the spark plug, prolonging the life 

of  the  exhaust  system.    Using  gasoline  of  low 

octane can cause persistent noise, and damage to 

the engine, if some of these occurs while running 

in constant speed under a normal charging load, 

change quality of fuel, occasionally your generator 

can make some noise while it operates under high 

charge of load.  This is not important, simply means 

that the generator is working efficiently.  

Verify the level of the oil of the engine before starting your 

generator, the level of the oil must be between the mark 

of low and high level of the  dipstick.

This product is send by manufacturer without oil.   

The  oil  is  very  important  in  the  engine 

performance.    Oils  with  detergents  and  vegetal 

oils are not recommended.    Do not add commercial 

additives to the recommended oil and don’t mix oil 

with  gasoline.    SAE  10W-30  is  recommended  for 

general use, other viscosities shown in the illustration 

can be used when the average temperature in their 

area is within the indicated rank. 

After  the  unit  is  running  you  can  connect  the  

appliances.

It is strongly recommended to use a GFI (Ground Fault 

Interrupter).  It can significantly reduce the possibility 

of injury if an electrical short occurs.

A  ground  fault  interrupter  may  ot  be  effective  if 

used on a generator that is not grounded.

When installing a GFI, be sure to follow all national 

and  local  regulations,  or  call  a  qualified  electrical 

technician.

Summary of Contents for G16MG0240M













Reviews: