Making Ice Cubes
NOTE:
For hygienic reasons do not use the ice
cubes from the first cycle.
1. Connect the mains plug to the wall
socket. Do not turn on the ice maker
within 30 minutes after moving.
2. Open the lid and remove the ice
cube container.
3. Pour water into the water tank up to the
MAX-marking. Please use drinking
water for making ice.
CAUTION:
Only use drinking water without additives!
NOTE:
• The MAX marking is inside the water
tank, around the lower edge of the ice
cube container.
• The water level must be below the ice
cube container.
• Only use water at room temperature.
4. Replace the ice cube container and
close the lid
5. Press
key to start making ice.
6. The process takes around 10 minutes.
7. Keep the lid closed.
NOTE:
• Depending on water/ambient temperature
the first ice cubes come out a bit smaller
• Due to fast freezing the ice cubes can
look milky. This is the air trapped in the
water and does not influence the
quality of the ice cubes.
Main switch
Press
to start / stop the ice cube production
Press
to resume making ice cubes
after adding water when water tank is empty;
the indicator lamp ADD WATER turns off.
Press
to eliminate errors
Indicator Lamp ICE FULL
• The lamp indicates the ice storage box is full.
Remove all the ice cubes from the box.
• The low temperature protection (ambient
temperature is lower than 5ºC)
Indicator Lamp ADD WATER
The Indicator lamp turns on if the water tank is
nearly empty .The unit turns off automatically.
1. Open the lid and remove the ice cube box
2. Pour water into the water tank up to the
MAX-marking. Please use drinking
water for making ice.
3. Replace the ice cube container and close
the lid. Press
key to start making ice.
Indicator Lamp RUNNING
• The indicator lamp starts flashing as soon
as unit was plugged into the wall socket.
• During operation indicator lamp
illuminates continuously.
CAUTION:
Wait at least 3 minutes before turning the
appliance on again, otherwise the
compressor can be damaged.
Cleaning
WARNING:
Always disconnect from mains power
supply before cleaning.
Stop Ice Cube Production
Press
key to stop Ice cube production
NOTE:
Before finally stopping the appliance
automatically empties the water tank and
dissolves already produced ice cubes.
CAUTION:
• Do not use harsh or abrasive
cleaning agents.
• Do not use chemicals, acids, petrol
or oil products.
• Do not submerge the appliance in water.
Page 4
Summary of Contents for EK IceMaker
Page 8: ......
