4. Handheld sprayer hose.
a. Connect the water line
(larger) hose to the sprayer.
b. Connect the electric line
(smaller) to the base of the
sprayer.
c. To remove water line from
electric gun handle, pull
back on quick release
coupler to remove
d. To remove electrical con-
nection push metal spring
loaded tab inward until
electric line is released.
5. Electrostatic on/off.
When the light is red, the
electrostatic component is on.
3
2
1
1. Sanitizing: adjust to the
small nozzle setting.
2. Disinfection: adjust to the
medium nozzle setting.
3. Soft surfaces: (linens/
carpet/outdoors) use
large setting.
5.
Changing the 3-in-1 nozzle (PX5
0
ES) settings. “Do not touch or insert
foreign object into the nozzle to avoid electric shock”. Adjust the
nozzle to the appropriate setting by using the nozzle wrench. Gently
rotate the wrench in the clockwise direction until you hear a “click.”
* PLEASE NOTE: If your nozzle becomes clogged, soak in hot soapy
water and blow out with pressurized air to remove blockage.When not
properly cleaned, the sprayer nozzle residual chemical deposits build
up. Deposit build up results in decreased bar pressure and decreased
spray patterns.
7. Optimal spraying distance.
To ensure optimal electrostatic performance
always keep your hand firmly wrapped around the handle and in contact
with the ground strap. Keep a distance of 2-3 feet from desired surface. Pull
the trigger and spray evenly.
8. Drain unit before storage.
Never store the sprayer with a full tank inserted.
Remove tank, prior to storing the sprayer, and use the tank lid to seal any
remaining
PURTABS
solution for the next use. Evacuate water fully from
sprayer tubing prior to storing. Regularly flush both sprayer and nozzles
by filling the tank with warm water and spraying each nozzle setting for
approximately 30 seconds. Wipe nozzle area dry after each use.
IMPORTANT:
Battery
door must be closed at all
times during use. Failure
to close the battery door
can cause damage if the
battery gets wet.
BATTERY OPERATION
1. Charge the battery for two hours before inserting the Protexus 16.8
volt battery into the backpack.
a. Plug the charger into an outlet and insert the battery until the power level
indicator shows a full charge.
2. Insert battery into backpack.
a. Open battery door by turning the knob counter clockwise
b. Align battery grooves and push battery until it clicks into the locked position.
c. Tighten the knob clockwise until secure.
SPRAYER SETUP
1. Remove the Sprayer Tank.
Pull the top tank latch release to unlock,
(see image) and carefully remove the tank.
2. Diluting PURTABS solution.
After selecting your concentration, fill the
tank according to the dilution chart. Drop the PURTABS ** tablet into the
tank. Close the tank lid, and wait approx. 2 minutes for the tablet to dissolve
completely. Label the date and ppm on a tank label. Please reference the
dilution chart for appropriate tablet size.
3. Inserting tank back into sprayer.
Place the tank on a flat surface, and
align the grooves of the tank with the sprayer. Insert the tank into the
sprayer until you hear the click of the tank locking back into place. Secure
the top latch back into place.
4. Apply appropriate tank labels.
Secure tank measurement guide label
alongside the edge of the tank. Apply Dilution (ppm) label in a visible location
on the tank. Labels may be removed and replaced as needed.
