15
5.4.2
The Hi HYS Menu
1.
Enter this menu by pressing the
MODE
key to the
“SEt”
display
if you are in the measurement
mode.
2.
Press
ENTER
key. If the
password has been set earlier,
key in the password using the
method described in section 4.1.
Press
ENTER
once to confirm.
After you set the correct
password, you see the “
CAL
”
and “
COn
” display blinks
alternatively. Press
▼
key thrice,
the display shows
“Hi”
“HYS”
blinking.
3. Press
ENTER
key to access the
Hi HYS menu and the display
shows the last Hi HYS value or
default (2% of Full Scale). Use
▲
and
▼
keys to change the
value of the Hi HYS point.
4. Press
ENTER
to confirm the
value of the Hi HYS.
5.
Press
MODE
key to exit to
measurement mode. You can
press
MODE
key (as an
ESCAPE key) to revert to the
measurement value if
ENTER
is
not pressed; the set value is not
stored into memory.
SETUP
MODE
ENTER
Hi
SETUP
MODE
ENTER
02
SETUP
MODE
ENTER
HYS
NOTE :
The
maximum value of
Hysteresis is 4% of its
Full Scale (FS)
selected. The HI HYS
hysteresis is spread
equally on either side
of the Hi SET point.
Summary of Contents for Alpha CON 100 C
Page 29: ...26 NOTES ...
