37
36
Pressure
piece falls
out (This
can also
cause an
E1-error).
Due to an
endless thread
the pressurepiece,
which is situated
at the bottom,
can fall out if the
device has not
been affixed on
the valve.
Put in the pressure
piece. The device can
be adapted by removing and
inserting the batteries. The
endless thread is rotating
now and fixes the pressure
piece again. Just install it to
the radiator and adapt
it once again.
ER1-ER3
The error code can be cleared by pres-
sing the boost button.
ERR
Inclusion failed.
Z-Wave Controller out of
range.
ER1
Valve positioning
not possible.
Check if the valve is
jammed.
ER2
Valve not
detected.
Check if the Spirit Z-Wave
Plus is correctly mounted.
ER3
Valves closing
point not
detected.
Check if the Spirit Z-Wave
Plus is correctly mounted.
Error
Cause
Solution
Batteries do not
have enough
power.
Replace batteries.
Heating
element
does not
warm up.
Is the boiler wa-
ter temperature
O.K.?
Valve does
not open, is it
calcified after the
summer pause/
heating pause?
Adjust the temperature of
the boiler water.
Remove the Spirit Z-Wave
Plus, move the valveback and
forth per hand or with a tool.
Heating
element
does
not cool
down.
Valve does not
close completely.
It may be that the
closing point
of your valve seat
has shifted.
Adapt again
(see “Adapting”) Move the
valve stem several times
by hand, it may be that
adaptation is impossible
because your valve is
calcifi ed or the seat
no longer performs its
function.
HELP AND ERROR MESSAGES
EN
EN
