Page 11
GENIUS LCD 100
6.5 ADAPTATION
After the installation has been completed, GENIUS LCD 100 is able to start adapting by holding down OK/SET for ap-
prox. 3 seconds. The device now adapts to the stroke of your valve body. To do this, the valve is now opened and closed
several times to learn the respective end points. The display shows
. This process may take some time.
After successful adaptation, the GENIUS LCD 100 switches to normal operation, the display shows the setpoint tempera-
ture.
|
If a new adaptation is necessary, e.g. if your radiator does not become cold in the OFF position, please select
ADAPTATION in the menu. Confirm with OK/SET and start the adaptation again.
|
If the error E1 appears in the display, place GENIUS LCD 100 on the radiator valve and then remove the batteries
briefly to perform a reset.
6.6 REMOVING
To remove GENIUS LCD 100, select MENU INSTALLATION MODE and confirm with OK/SET. Wait briefly
until the motor movement shown by an animation is completed and ADAPTATION appears in the display.
Now turn the union nut counterclockwise and remove the
GENIUS LCD 100 from the valve (ill.7).
i
l
l
.
7
