Eurotherm TC3001, User Manual

Page: 42 / 79

Transit Inspector Pro 43
Administrating Module
User Guide
•
X
—
0
,
Y
—
0
,
W
—
60
,
H
—
60
.
11. Create Transit: operator GUI object. Set the following parameters:
•
Display settings
→
select recognizers to display its results. For each object set the
Monitor object to display operator interface.
•
Number window
:
X
—
0
,
Y
—
60
,
W
—
60
,
H
—
40
;
• Protocol window : X —
60
, Y —
0
, W —
40
, H —
100
;
•
Display ... last trains
→ set number of trains to display in Protocol window.
• Enable searching → select the checkbox to allow operator to search in database.
•
Allow number editing
→
select the checkbox to allow operator to edit recognized number.
12. Exit the administration mode.
4.3.2 Server-Workstation Configuration
1. Open the Computer object properties (see SecurOS Administration Guide ) and setup the follow-
ing parameter:
•
Disks to store archive
→ set
Read/Write
access for video for at least one hard disk (e. g.
for
C
).
2. Create Video Capture Device object (see SecurOS Administration Guide ).
3. Create Camera object with the following parameters:
•
Channel number
→
set the actual number of the labeled BNC connector the first camera
is attached to.
•
Resolution
→ set
High (CIF2)
value.
• Pre-recording phase duration → set approximate train passing time (s) by camera view.
4. Create Sensor object (see 4.2.3 Transit: number recognizer on page 25 ) and define Alarm
condition
on train passing by (on sensor applying for train partition).
5. Create Database object (see 4.2.2 Database on page 24 ). Define database for recognized number
records and retention period optionally.
6. Create the Transit: number recognizer object (see 4.2.3 Transit: number recognizer on page 25 )
with the following parameters:
• Analyse video from camera → define the corresponding Camera object.
•
Synchronously record video from cameras
→
define additional cameras to record video.
•
Video recording mode
→ select the proper recording mode.
•
Recognize numbers of wagons incoming from
→
select the proper checkboxes due to
the task.
•
Redirect results to
→
define the Database object or enable the Consolidator field if the
current recognizer is not a main one.
www.isscctv.com