ReliaGATE 10-20 User Manual
Interfaces
19
110129-00011
Secure the ReliaCELL 10-20 to the bay on ReliaGATE 10-20 as described in the Mechanical section of this
manual. Follow the guidelines in the ReliaCELL user manual for antenna selection.
All Eurotech operating systems are designed to support the ReliaCELL 10-20.
USB OTG
Connector
USB OTG mini Type B socket
Mating connector
USB OTG cable, mini Type B plug
This socket supports a USB On-the-Go connection. This socket can be used to restore unit with corrupted
software. Contact factory for current level of software support.
MicroSD
Connector
microSD socket, push-push type
Mating connector
microSD storage card
Use a microSD card into the "SD" socket to expand storage capacity of the ReliaCELL 10-20.
Insert the card until it clicks into place. Press on the card again to eject it.
SIM
Connector
SIM socket, push-push type
Mating connector
SIM card from a cellular service provider
If your model of the ReliaCELL 10-20 includes an on-board cellular modem, you may need to insert a SIM card
from your cellular service provider into this slot. Insert the SIM until it clicks into the socket. Press on the SIM a
second time to eject it.
If you are using a ReliaCELL cellular modem, any required SIM should be installed in the ReliaCELL enclosure,
and not in this slot.
Debug
Connector
Three-pin, 0.1 inch pin header
Mating connector
None
The debug connector provides two signals that can be used during product development. Pin 1 located closest
to the center-line of the front panel, pin 3 is toward the corner. Used for unit recovery if software becomes
corrupted.
Pin
Signal
Description
1
Reset#
Short to ground to reset the system.
2
GND
Ground
3
SD2_Boot
Shunt to ground to boot from SD.
