User manual - EUROPRO 50TH / EUROPRO 100TH
202009-491-ENG
P10
4. USE OF THE MACHINE
4.1. PREREQUISITES
•
Before each use of the compressor, check the fuel level in the tank (F) and refill if necessary.
• Check the oil level in the engine using the dipstick (M).
If necessary, fill with 15W40 oil until the MAX level is reached.
•
Check the oil level in the compression head with the eye (D).
If necessary, fill with ISO INH 100 oil until the MAX level is reached.
• Open the air valve (G) to prevent the pressure in the tank from increasing.
4.2. STARTING UP
1. Open the fuel valve (J).
2. Turn on the starter (I).
3.
Switch the engine ignition switch (L) (or ignition key (L)) to the ON position.
4. Move the throttle lever (N) to half position.
5. Pull the launcher to start the compressor.
6.
After a few seconds remove the starter and close the air valve (G).
7. Connect the coupled equipment (spraying machine, etc...) to the valve (G) and open it.
8. The compressor is ready for use.
4.3. STOPPING OF THE COMPRESSOR
1. Close the valve (G) and drain the air in the hose.
2. Disconnect the equipment connected to the compressor.
3.
Open the drain screw and let the compressor run for about 2 minutes to drain the condensation that
has formed in the tank.
4.
Turn the switch or the key (L) to the OFF position to switch off the compressor.
5.
Close the drain screw again.
