Document ID: 39080000
Rev: C
Technical Support: 1-800-626-6912
Page 13 of 26
STEP 7a – Unit purchased without Power Drain Pump
Tighten a 1½” coupler to the end of the PVC pipe sticking out of the basin. Continue to route the
plumbing as needed using 1½” Schedule 40 PVC.
STEP 7b – Unit purchased with Power Drain Pump
Run the black hose underneath the extension towards the back of the extension. Remove the brass
nut, rubber o-ring and nylon ring from brass bulkhead fitting
.
Pass the bulkhead fitting through the
small left hole in the back of the extension. Place the rubber o-ring, then the nylon o-ring onto the
fitting and tighten brass nut using the Crescent or Channel Locks Wrench and grasping the brass
fitting through the access panel.
STEP 8
Push the basin towards the extension and find the (4) ¼-20 bolts and (4) washers. Attach the
extension to the rear of the basin using a 7/16” Wrench or Socket.
WARNING:
Do not lift unit once extension is assembled to basin.
