Euromate 450 297, Original Instructions Manual, Page: 23 / 100

GB
23
– Press and hold down the spindle lock (9).
– Turn the tensioning screw (18) using the
supplied mounting wrench in an anti-
clockwise direction.
– Remove the tensioning flange (19) from
the motor shaft.
– Open the pendulum protective hood with
pullback lever (7) fully.
– Remove the saw blade (5) from the motor
shaft and carefully remove by taking
downwards.
Fitting a saw blade
– Clean all pieces to be mounted before
installation.
►
P. 5, item 7
– Put the new saw blade (5) into place.
– Fit the tensioning flange (19).
– Fit the washer (20).
– Screw the tensioning screw (18) into
place using the supplied mounting
wrench and turning in an anti-clockwise
direction.
Troubleshooting
What to do when something doesn’t
work…
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
If you can’t fix the fault yourself, contact your
nearest vendor. Please be aware that any
improper repairs will also invalidate the war-
ranty and additional costs may be incurred.
DANGER! Risk of injury!
The ten-
sioning screw may not be tightened
too far. This may cause damage to
the unit and serious injury!
Remove the mounting wrench before
turning the power tool on. A wrench
or a key left attached to a rotating
part of the power tool may result in
personal injury.
WARNING! Risk of injury!
When
installing, ensure that the saw blade
sits correctly on the motor shaft. Oth-
erwise the saw may block or the saw
blade come undone!
NOTICE! Risk of damage to the
unit!
Make sure that the saw blade is
installed in accordance with the rota-
tion direction of the blade!
The arrow
direction on the saw blade and the
unit must match
.
DANGER! Danger to life and limb!
Unprofessional repairs may mean
that your unit will no longer operate
safely. This endangers you and your
environment.
Error/Fault Cause Remedy
Device does not work No power supply? Check the cable, plug, and the
fuse.
Is the device defective? Contact your local vendor.
Sawing performance is not
good enough.
Saw blade is blunt? Replace the saw blade
(
►
Changing the saw blade –
p. 22).
Saw blade not suitable for the
materials?
Saw blade distorted?
Saw vibrates heavily.
Saw blade mounted incorrect-
ly?
Mount saw blade correctly
(
►
Fitting a saw blade – p. 23).
temp.book Seite 23 Donnerstag, 10. August 2017 8:39 08