Euromate 450 297, Original Instructions Manual, Page: 22 / 100

GB
22
– Check to make sure there are no visible
defects.
– Check to make sure all unit components
are correctly mounted.
Cut markings
The cut markings (4) show the position of the
saw blade for a right-angled cut (mark-
ing
[0°]
) and for a 45° cut (marking
[45°]
).
Sawing
– Place the material to be cut on an even,
suitable surface and secure to prevent it
slipping.
– Mark the line of the cut.
– Set the required cutting depth (
►
Setting
the cutting depth – p. 21).
– Hold the saw firmly with both hands.
– Place the base plate (13) on the work
piece in such a way that the saw blade
touches nothing and the cut markings (4)
lie on the cutting line.
– Press the On/Off switch (1) with the
switch lock (10) held down and hold them
down.
– Wait until the blade has reached maxi-
mum cutting speed.
– Guide the saw forwards across the work
piece, keep it horizontal and moving con-
stantly forwards until the cut is completed
(never pull the saw backwards!)
.
Cleaning and maintenance
Cleaning and maintenance overview
Before each use
Regularly and according to the operating
conditions
Changing the saw blade
Removing the saw blade
►
P. 5, item 6
DANGER! Risk of kickback!
Always guide the saw, never the
work piece!
Always hold the device tightly with
both hands.
Never pull the saw backwards!
Never tilt the blade!
When sawing, the base plate must
rest safety and fully on the work
piece.
DANGER! Risk of injury!
Never use
your hand to hold the work piece
when working! Always clamp the
work piece firmly in place.
Do not process work pieces that are
too small to be clamped.
NOTICE! Risk of damage to the
unit!
Only use saw blades that are
appropriate for the material you are
processing.
Always operate the saw with gentle
force.
Note:
To achieve clean cuts, keep to
a straight cutting line and guide the
saw forwards at a constant speed.
DANGER! Danger to life and limb!
Pull out the power plug before con-
ducting any maintenance work on
the device.
Only those maintenance and fault
elimination tasks described here may
be carried out. Any other tasks must
be completed by a specialist.
What? How?
Check the power ca-
ble and plug for dam-
age.
Visual check.
Check all screw con-
nections and tighten if
necessary.
What? How?
Clean the ventilation
slots of the motor to
remove dust.
Use a vacuum, clean-
ing brush or paint
brush.
Clean the device. Wipe the unit with a
damp cloth.
DANGER! Risk of injury!
Pull out
the power plug before conducting
any maintenance work on the device.
WARNING! Risk of injury!
Shortly
after sawing, the saw blade may be
very hot. Allow a hot blade to cool
down. Never clean a hot saw blade
with flammable liquids.
A still saw blade can cause injury!
Use gloves to change the saw blade.
temp.book Seite 22 Donnerstag, 10. August 2017 8:39 08