EN
7
Using the assembly clamp
1. Prepare the worktop as shown.
2. Remove the sealing gasket from the packaging.
3. The sealing gasket provided in the package must be affixed around the
glass frame on the lower surface as shown in the figure, during installation
of your hob.
4. Center the appliance in the counter.
5. Tighten the screws of the springs located on the base of the appliance
to secure the appliance in position.
��
�
�
�
��
�
A ventilation opening of min. 180
cm
2
should be provided at the rear
side of the furniture.
If there is an oven below;
If there is a board below;
During installation of your induction hob, special care should be paid to place the product parallel
to the installation surface. Furthermore, leaking of any kind of liquid between the product and the
counter must be prevented by applying the sealing gasket under the hob as described above.
4 cm
min 45 cm
7 mm
min
Installation to your hob must be performed with the supplied
assembly clamp as described in Figure 1. An assembly clamp
must be installed to the points indicated in the Figure 2, which
shows the bottom view of the hob.
Bottom view of
the hob
Figure 2
Worktop
Assembly clamp
Figure 1
Hob
