ffDANGER:
\Jhe power cable must not be clamped,
bent or trapped or come into contact
with hot parts of the product.
A damaged power cable must be replaced
by a qualified electrician. Otherwise, there is
risk of electric shock, short circuit or fire!
The mains supply data must correspond to the
data specified on the type label of the product.
The rating plate is either seen when the door or
the lower cover is opened or it is located at the
rear wall of the unit depending on the unit type.
Power cable of your product must comply with
the values in "Technical specifications" table.
\Before starting any work on the
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Plug the power cable into the socket.
Gas connection
Product can be connected to gas
supply system only by an authorised
and qualified person.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
<Before starting any work on the gas
installation, disconnect the gas supply.
There is the risk of explosion!
•
Gas adjustment conditions and values are
stated on labels (or ion type label).
•
This product is suitable for connection with
an AGA approved hose assembly.
16/EN
Suitable for Flexible Hose Connection
Connection hose must comply to AS1869
class B 10mm diameter & be AGA certified
lenght of hose is to be as short as possible
hose length must not exceed 1.2m the hose
must not be kinked or be able to touch any
hot surface when installed.
Gas connection for Natural Gas only- 1.0 kPa
Appliance should be connected using an isolation
valve, union and re ulator.
-------,,,
Test point
2
Gas regulator
3
Elbow
4
Gas inlet pipe
2
3
4
Connecting with hose assembly
GasConn_AtJstr _NG
Where a hose assembly is to be used for the gas
connection to this appliance it must :
•
Comply to AS1869 Class B 10 mm
diameter, be AGA gas.
•
Be a short as possible, but in no case
belonger than 1.2 m.
•
This appliance is suitable for installation
with a hose assembly.
•
The hose must not be able to tuch any hot
surface of be kinked when appliance is
installed.
•
At the completion of the installation, test for
leaks.
Do not use Naked Flame to test for leaks.
only.