EUROM HKG 15-NL, Manual

Page: 18 / 24

18
Operation:
1. Check the heater for damage or defects. Do not use a damaged heater, but contact
your supplier.
2. Make sure to use undamaged, full gas bottles with propane or butane, suitable for
use.
3. Select a place for the heater that meets all the safety instructions and place it on a
level, stable, horizontal surface with non-flammable material. Do not plug it in and
the set the power switch to O (off).
4. Firmly attach the gas hose with suitable tools to the pressure regulator (left screw
threads!)
5. Remove the protective cap and attach the gas supply hose to the device (left screw
threads!). Firmly screw on the nut with
suitable tools for unproblematic gas
supply (Diagram 1).
6. Connect the pressure regulator to the
gas bottle. Firmly screw the nut on so
that no gas leakage can occur. Make
sure when you install the gas bottle that
the gas hose is not bent or kinked. Avoid
turned and pulled tension.
7. Check that the device is correctly
attached to the gas bottle and perform a
complete gas leakage test (see the
description below in this booklet).
8.
When you’re sure everything is in order,
open the gas tap. (Diagram 2).
9. Turn the regulator button to the
maximum position.
10. Now insert the plug into the socket. Then
set the power switch to I (on) (Diagram
3). The ventilator will start running.
11. Wait until the ventilator is running
steadily and stable. Now press the right-
hand button of the gas valve and keep it
pressed down for 10 seconds. Then with
your left hand simultaneously press the
ignition button a few times to ignite the
device (Diagram 4).
12. After the gas starts burning, keep the gas
valve pressed in for another 15 seconds.
After that, you can let go and the gas will
burn continuously (Diagram 5).
13. Now turn the regulator button until it reaches the desired flame length, in accordance
with your desired heat output.