11
Adjust the desired angle of radiation. The heater can turn on the bracket but never direct it
upwards (keep it facing forwards) and do not exceed a downward angle of 20° from the wall.
Then secure the bolts.
Pay attention that the radiator doesn’t focus its heat from a short
distance at combustable materials!
Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now your
infra red heater is ready for use.
For personal protection the installation, to which the EUROM GOLDSUN is connected, has to
be equipped with an earth fall device (max. 30 mAmp). Under some circumstances it may be
attractive to make a fast connection between the heater and the main supply, and to operate the
heater with a switch. Because the EUROM GOLDSUN has a high water tightness (IP65) and for
safety reasons, such a connection has to be made by a qualified electrician.
WORKING
Check for every use:
-
or the appliance doesn’t show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o wind
or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (230V-50Hz and is earthed.
If everything is all right you can insert the plug into the socket. The infra red heater will start to
work. When you use the appliance for
the first time (or after a long time again), observe it during the first 10 till 15 minutes to be sure
that is works trouble-free.
To stop the heater, take the plug out of the socket and give the heater time to cool down.
CLEANING - MAINTENANCE - SERVICE
Before cleaning or performing maintenance remove the plug from the power outlet and
wait until the appliance is sufficiently cooled off.
Lamp
Never touch the lamp with bare hands. If this occurs, try to remove the fingerprints (through the
grille) with a soft, dry cloth (you may also use a volatile solution such as alcohol). Fingerprints
can shorten the life-expectancy of the lamp! The heater may never be opened by an
unauthorised person.
Cleaning
This appliance consist of a robust and maintenance-free aluminium casing with a safety grill.
Wipe the appliance only with a clean and lint-free cloth or a soft brush. Never use abrasive
cleaners, scrubbing brushes and chemical cleaners for cleaning! Never use flammable cleaners
such as benzene or spiritus. Give the appliance time to dry before you use it again.
To protect against electrical shock and danger of life, do not immerse cord, plug or any part of
the appliance in water or other liquid.
The German reflector is made of highly polished aluminium and should not lose its reflective
property as a result of dirt or dust. You do not have to clean it very often. If this is necessary
from time to time, use a small, soft brush through the grille. Do not touch the lamp!
