124
EN
2. INSTALLING THE MA-
CHINE
2.1 Positioning the machine
When determining the place to put your
machine on, take care to choose a place
where you can easily load and unload
your dishes.
Do not put your machine in any location
where there is the probability for the
room temperature to fall below 0°C.
Before positioning, take the machine out
of its packaging by following the warn-
ings located on the package.
Position the machine close to a water
tap or drain. You need to site your ma-
chine, taking into consideration that its
connections will not be altered once they
are made.
Do not grip the machine by its door or
panel in order to move it.
Take care to leave a certain clearance
from all sides of the machine so that you
can comfortably move it back and forth
during cleaning.
Make sure that the water inlet and
outlet hoses do not get squeezed
while positioning the machine. Also,
make sure that the machine does not
stand on the electrical cable. Adjust the
machine's adjustable feet so that it can
stand level and balanced. Proper posi-
tioning of the machine ensures prob-
lem-free opening and closing of its door.
If the door of you machine does not
close properly, check if the machine is
stable on the
fl
oor it stands; if not, adjust
the adjustable feet and ensure its stable
position.
2.2 Water connection
Be sure that the
indoor plumbing is
suitable for install-
ing a dishwasher.
Also, we recom-
mend that you
fi
t a
fi
lter at the entrance
of your place or
apartment so as to
avoid any damage
to your machine
because of any
contamination (sand, clay, rust etc.) that
might be occasionally carried in through
the mains water supply or the indoor
plumbing, and to forestall such com-
plaints as yellowing and formation of de-
posits after washing.
2.3 Water Inlet Hose
Do not use the wa-
ter inlet hose of
your old machine,
if any. Use the new
water inlet hose
supplied with your
machine instead.
If you are going to
connect a new or
long-unused water
inlet hose to your
machine, run wa-
ter through it for a while before making
the connection. Connect the water inlet
hose directly to the water inlet tap.The
pressure supplied by the tap should be
at a minimum of 0.03 Mpa and and at a
maximum of 1 Mpa.
If the water pressure is above 1 Mpa,
a pressure-relief valve should be
fi
tted
inbetween. After the connections are
