EN
97
Switching the Appliance On and O
ff
If the appliance is in Stand-By mode, it
is put in Operating mode by pressing the
On/O
ff
button for at least 1 second.
A buzzer will sound to indicate the suc-
cessful operation.
A “
0
” will appear on all heater displays
and all decimal points corresponding
to the heaters will
fl
ash (1 second on, 1
second o
ff
).
If there is no operation within 10 sec-
onds, the display on all heaters will
switch o
ff
.
If the displays do switch o
ff
, the heater
will be sent into Stand-By mode.
If is pressed for more than 2 seconds
(in Operating mode), the appliance will
switch o
ff
and will enter S-Mode again.
The appliance can be switched o
ff
by
pressing at any time; even if other
buttons are pressed simultaneously.
If there is any residual heat from a heat-
er, this will be indicated in the corre-
sponding Heater Display with a “
H
”.
Selecting a Heater
If a single heater is chosen with the cor-
responding Activate/Deactivate Heat-
er Button , the decimal point of the
Heater Display will
fl
ash. For the se-
lected heater, the heat level can be set
between 1 and 9 by pressing the Heat
Setting Buttons
or
.
The buttons must be pressed within 3
seconds of selecting a heater, otherwise
the heater selection will be erased and
the heat setting decimal point will dis-
appear. If there is no further operation
within 10 seconds, the heater will revert
back to S-Mode.
The heat setting can always be changed
by pressing
or
. The available
settings are between 1 and 9.
Each button operation or each display
change is accompanied by a buzzer
sound.
Switching On the Dual Zone
The activation of the dual zone is carried
out after selecting the desired heater
by pressing . This is con
fi
rmed by a
buzzer sound. At the same time, the
corresponding Dual Zone Indicator
illuminates. Touching for a second time,
toggles the status of the dual zone; it
changes from dual zone on to dual zone
o
ff
and back again.
The extension zone can only be
activated after a level between 1-9 is set
on the basic zone of the heater.
Set Cooking Level with and without
Heat Boost
All heaters are equipped with heat boost
functionality.
If the heat boost is active, the heater will
be operated with maximum power for the
period of the heat boost time, which is
dependent on the selected heat setting.
This is indicated through a
fl
ashing “
A
”,
alternating with the heat setting value
Mode Descriptions
Stand-By Mode
S-Mode
The mains is ap-
plied to the hob
control and all
heater displays
are o
ff
or a resid-
ual heat display
is active.
Operating-Mode
B-Mode
At least one
heater display
shows a heat
setting between
“
0
” and “
9
”.
Lock Mode
VR-Mode
The hob control
is locked.
