Assembly Instructions for Integrated Dishwasher
Mounting the Wooden Panel onto the Door and Sliding the Dishwasher into
the Cabinet
During the preparatory stages for installing the dishwasher into the kitchen cabinet, holes must not be
drilled in the sides, or door, in order to avoid compromising the performance and/or operation of the
appliance. Before working on any internal components, the unit must be disconnected from the power
supply .The maximum dimensions for the wood panel that can be installed on the door are: Height -
725 mm for the completely built-in version; Width - 448 mm; Thickness-20 mm.
The height dimension of 725 mm must be reduced if the height of the control panel is increased
through the use of the spacers. In addition, the base must be trimmed if it interferes with the opening
of the door.
Align the top edge of the template (identified with the “A” arrow ) with the top edge of the panel. On
both sides of the template (top and bottom ) are written the various dimensions that correspond to the
different possible widths for the panel. Align the template with the side of the panel (left or right),
making sure that the panel coincides with the appropriate dimensions. Mark the positions for the holes
for the screws, using the tip of a drill or a pencil. The three holes closest to the side should be used(B).
Repeat this step on the other side of the panel ,using the corresponding side of the template.
Using the Drilling Template
8
en
A
B
Fig.1
Summary of Contents for DW9-CBE7
Page 1: ...Code 012050 Dishwasher DW9 CBE7 Instructions for Use ...
Page 36: ......
