Eurolux DW9-CBE7, User Manual

Page: 10 / 36

At the point marked, drill holes 2 mm in diameter . If the panel is
made of chip board , only drill through the veneer. If the panel is
made of solid wood, the holes can be made deeper. Position the
two brackets so that they are lined up with the holes made in the
bottom part of the panel. The holes furthest to the outside should
be used to fasten the brackets. The small fins should be turned
downward. The hooks should be screwed into the two holes at
the top.
Fastening the Bracket to the Wooden Panel (Fig.2 )
Place the wood panel onto the door of the dishwasher. Then per-
form the installation steps described below,
Mounting the Wood Door Panel onto the Dishwasher
Insert the top hooks into the appropriate slots in the dishwasher
control panel. Then push the panel upwards until it stops. After-
wards , slide the panel downward again, moving the bottom of the
panel toward the door so that the fins on the brackets slide into
their slots (Fig.3).
In both cases, open the doors of the dishwasher (the panel should
stay in place by itself) and align the panel with the door, keeping it
in contact with the control panel. Remove the small plastic plugs
that cover the holes on the inside of the dishwasher door and fas-
ten the panel in place with the screws provided (Fig. 4). Remem-
ber to cover the two holes with the plastic plugs removed earlier.
The door must be perfectly balanced. In the factory , the tension
of the springs is regulated to ensure that the door is perfectly
balanced when light wood door panels are mounted on the door.
If heavier, solid wood door panels are used, the door can be bal-
anced by simply turning the two screws (both screws must be
turned the same amount) located on the top part of the machine.
Adjusting the Door Springs (Fig.5B)
9
en
2-7Kg
Fig.3
A
B
2Kg
7Kg
Fig.5
Fig.4
Fig.2