Eurolux DW10VEE-A++AA-8, User Manual

Page: 107 / 129

Prior to using the machine for the
first
time
• Check whether the electricity and supply water speci
fi
cations match the values indicated by the
installation instructions for the machine.
• Remove all packaging materials inside the machine.
• Set the water softener.
• Add 1 k g salt into the salt compartment and
fi
ll with water up to a level at which it will almost
ove
rfl
ow.
• Fill the rinse aid compartment.
The importance of water decalci
fic
ation
For a good washing function, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white
lime residues will remain on the dishes and the interior equipment. This will negatively a
ff
ect your
machine’s washing, drying and shining performance. When water
fl
ows through the softener system,
the ions forming the hardness are removed from the water and the water reaches the softness
required to obtain the best washing result. Depending on the level of hardness of the in
fl
owing water,
these ions that harden the water accumulate rapidly inside the softener system. Therefore, the
softener system has to be refreshed so that it operates with the same performance also during the
next wash. For this purpose, dishwasher salt is used.
Filling with salt
Use softener salt spec
ifi
cally produced for use in dishwashers. To
put softener salt,
fi
rst remove the
lower basket and then open the salt
compartment cap by turning it At
firs
t
fill
the
counter clockwise.
1 2
compartment with 1 kg salt and
water at ove
rfl
owing level If 3
available,using the funnel provided 4
will make
fi
lling easier; re
fit
the cap
and close it.When salt absent indicator
is lighten on ( app. between 20th-30th
cycles depend on the water hardness )
add salt into your machine until it fills up
(approx. 1 kg) Fill the salt
compartment with water at
firs
t use
only. We recommend that you use
small- grained or powder softener salt.
Do not put table salt into your
machine. Otherwise, the function of
the softener compartment may
decrease over time. When you start
your dishwasher, the salt
compartment ge
ts filled
with water. Therefore, put the softener salt prior to starting your machine.
This way, over
fl
owing salt gets immediately cleaned up through the wash operation. If you are not
going to wash any dishes immediately after putting salt, then run a short washing program with an
empty machine in order to avoid any damage ( to prevent corrosion ) to your machine due to the salt
ove
rfl
ow w
hile fi
lling in the salt container.
PREPARING THE MACHINE FOR USE