7
VP2002
5.2 General Viewing Functions
5.2 General Viewing Functions
Make sure the STB is correctly connected and confi gured. Turn on the ignition
key of your car and make sure that your screen unit is switched on. The TV
receiver should power on automatically. If not, press button
on the RCU
to turn on the power. A TV channel will be shown and the information box will
be displayed for a few seconds. The channels shown will depend on the initial
programming.
If the incorrect language mode has been
programmed, see
section 6.3.1
OSD
Language
5.2.1 Volume & audio control
Volume Control
To increase or decrease the volume, use
VOL◄,VOL►
on the RCU. The volume
can not be adjusted when any menu is displayed. To return to normal TV mode,
press the
Exit
button (several times, if necessary)!
To mute the sound altogether, press . To return to normal sound, press
again.
Audio Control
Press the
AUDIO
key repeatedly to select one of three possible Audio settings
(Left, Right and Stereo)
The current audio setting will be displayed in the channel information.
Language Selection
Press the
LANG
key on the RCU repeatedly to select the audio language. The
availability of this function is dependent on the audio signal transmission.
Note: Smart Card / Chip Card:
The TV channels that can be viewed depend on their being ‘free-
to-air’ (freely available). In some countries viewing certain channels
may require a SmartCard. Please refer to the countries network
provider for obtaining smartcards when needed. Depending on the
country where you buy the unit, a smartcard may be provided with
the unit.
