18
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1:
Unscrew the fixation screw(s) of the service lid.
Step 2:
Remove the service lid.
Step 3:
If replacing the lamp, remove the old lamp from the socket.
Step 4:
Insert the EFR 15 V/150 W GZ-6,35 lamp into the lamp-socket.
Step 5:
Replace the service lid and tighten the screw(s).
Do not operate this device with opened service lid!
Rigging
Mount the projector with the mounting-bracket to your trussing system using an appropriate clamp. The hole
in the mounting bracket has a diameter of 10 mm.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture. Install
the safety-rope at the whole in the mounting-bracket.
Adjust the desired inclination-angle via the mounting-bracket and fix the bracket-screws tightly.
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the TS-3 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can be
used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Occupation of the DIP-switches:
1 2 3 4 5 6 7 8 9
ON
1 2 3 4 5 6 7 8 9
ON
1 2 3 4 5 6 7 8 9
ON
1 2 3 4 5 6 7 8 9
ON
Projector 1
MASTER
Projector 2
Slave 1
Projector 3
Slave 2
Projector 4
Slave 3
Blackout control
If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode), connect your footswitch
via a mono-jack plug to the Blackout-socket.
