51786410_V_2_3.DOC
30/63
F3 - 16 Bit operation
With this function you can reduce the projector-movement to 16 bit.
•
Press the
Function
button and select
„F3“.
•
Press the
Up
button to select
“y”
if you wish to enable this function or press the
Down
button to select
“n”
if you don’t.
F4 - Demo operation
In the Stand Alone mode, the TMH-155 can be used without controller. Disconnect the TMH-155 from the
controller and call up the internal program (F4).
•
Press the
Function
button and select
„F4“.
•
Press the
Up
button to select
“y”
if you wish to enable this function or press the
Down
button to select
“n”
if you don’t.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the TMH-155 will respond to the controller.
Please, be sure that you don’t have any overlapping channels in order to control each TMH-155 correctly
and independently from any other fixture on the DMX data link.
If two, three or more TMH-155 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all TMH-155, you may now start operating these via your lighting controller.
Note:
After switching on, the TMH-155 will automatically detect whether DMX 512 data is received or not. If the
data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights
up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TMH-155.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control channel 1 - Horizontal movement (Pan) (within 360°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control channel 2 - Vertical movement (Tilt) (within 250°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
Summary of Contents for TMH-155 Moving-Head
Page 12: ...51786410_V_2_3 DOC 12 63...
Page 27: ...51786410_V_2_3 DOC 27 63...
Page 42: ...51786410_V_2_3 DOC 42 63...
Page 57: ...51786410_V_2_3 DOC 57 63...
