00110564, Version 1.0
27/36
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller.
The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the
MENU
button so many times until
SLAU
is indicated in the display. Confirm with the
ENTER
button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.
Remote control IR-7
The device must be activated for remote control. For this, set menu item
InFr
to
on
. When actuating a
button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Button
Function
BLACKOUT
LEDs off
AUTO
Automatic mode; program selection with (+)/(‒)
SOUND
Sound control; program selection with (+)/(‒)
STROBE
Strobe effect for automatic mode and sound control;
flash rate setting with (+)/(‒)
SPEED
Running speed in
automatic mode;
setting with (+)/(‒)
SENSITIVITY
Microphone sensitivity;
setting with (+)/(‒)
DMX
DMX mode
MANUAL
Color mode; select colors with R/G/B and (+)/(‒)
FADE
Color fade mode
1-9
Total brightness;
1 = dark, 9 = bright
Notes:
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
•
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
