10
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The rotary motor should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the mirrorball. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The installation spot must be chose in a way that the motor can be installed in an absolutely horizontal
position.
The motor and the mirrorball have to be installed out of the reach of people.
If the motor shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The motor must never be fixed swinging freely in the room.
Caution:
Mirrorballs may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the motor!
Before rigging make sure that the installation area has to hold a minimum of 400 kg point load.
Please install the mirror ball motor via all 4 fixation holes.
Do only use appropriate screws and make sure that the srews are properly connected with the ground.
Connection to the mains
Connect the device with the 3-pole power supply cable to the mains.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
The mirrorball has to be connected via an appropriate installation (see above) with the motor. We
recommend to use the Chain for Mirrorballs up to 100 cm certified, 100 cm, No. 50301616.
The mirrorball has to be secured via an appropriate safety chain. This chain has to be built and constructed
in a way that it can hold 12 times the weight for 1 hour without any harming deformation.
The installation material must never include abrading material e. g. steel cables in order to avoid
material wearing.
The length of the chain must never exceed 100 cm.
Install the mirrorball chain with the screw-on chain link at the installation eyelet of the mirrorball and tighten
the fixation screw.
Insert the fourth chain link of the mirrorball chain with the mirrorball in the screw-on chain link and tighten the
fixation screw.
For overhead use, always install a safety chain on the mirrorball that can hold at least 12 times the weight of
the installation. The safety chain must be slightly longer than the mirrorball chain so that the safety chain will
