00054285, Version 1.3
25/30
OPERATION
With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the EUROLITE LED TMH-10 Spot starts running. During the
Reset, the motors are trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.
Stand Alone operation
In the Stand Alone mode, the LED TMH-10 Spot can be used without controller.
Disconnect the LED TMH-10 Spot from the controller and call the internal program. Please refer to the
instructions under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode - „Automatic program mode“ or „Sound controlled mode“ - for the master-
device. Set the DMX address 1 for all slave-devices.
Control Board
The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
The main menu is accessed by pressing the Mode/Esc-
button. Browse through the submenu by pressing Up or
Down. Press the Enter-button in order to select the desired
menu. You can change the selection by pressing Up or
Down. Confirm every selection by pressing the Enter-
button. You can leave every mode by pressing the
Mode/Esc-button. The functions provided are described in
the following sections.
ENTER
MODE/ESC
UP DOWN
