00056924.DOC, Version 1.1
22/26
Master / Slave Mode
Set the Master device to Auto (P) or Sound Control (SoUd) mode.
To set the respective Slave devices, press the MODE button until each display shows
SLAV
.
In order set Slave mode, press the MODE button until each display shows
PEVE.
You can choose the desired mode via the UP and DOWN buttons:
ON
= Slaves controlled by Master device (ON=default setting)
OFF
= Slaves function inversely from the Master device.
DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED SCY-200 TCL DMX will respond to the controller.
Addressing
Press the MODE button until the display shows
Addr
. You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
Value:
Add
1 - 512
Controlling:
After having addressed the LED SCY-200 TCL DMX, you may now start operating it via your lighting
controller.
Note:
It’s necessary to insert the XLR termination plug with 120
in the last lighting in the link in order to ensure
proper transmission on the DMX data link.
Choosing a DMX Channel Mode with 7 or 20 Channal Occupation
The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
Setting DMX Mode
After setting the desired address via the UP or DOWN buttons, press the MODE button again and the
display shows
7_CH
.
In case you would rather select the 20-channel mode, press the DOWN button in order to choose the
20_CH
setting.
Mode:
Value:
7_CH (default setting)
20_CH
